[Top] [Prev] [Next] [Contents] [Index]
NCDDM Messages
NCDDM messages pertain to the NCD Display Manager. If you are looking for a message that refers to the NCDDM module but is not listed here, see "Messages Common to All Modules".
COMERR, communication error with ncddm server message
- Severity:
- Error
- Explanation:
- The X server was unable to connect to the ncddm daemon or
experienced a read or write error after the connection was established. The
message specifies which of these possible errors occurred.
- User Action:
- Check for network problems. Check to make sure the daemon
was started.
PROTOERR, protocol error with ncddm server message
- Severity:
- Error
- Explanation:
- There was an internal problem in either the ncddm daemon
running on the host or the ncddm client running in the terminal. The message
gives specific information.
- User Action:
- Please contact NCD Technical Support.
REQFAIL, ncddm server returned failed request
- Severity:
- Error
- Explanation:
- The ncddm daemon was unable to respond with appropriate
information. Check the ncddm error logs or turn on debugging. Debugging is
turned on through command-line options; see the ncddm man page.
- User Action:
- Please contact NCD Technical Support.
[Top] [Prev] [Next] [Contents] [Index]
Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at
techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights
reserved.