[Top] [Prev] [Next] [Contents] [Index]

Specifying the File for Loading Configuration Defaults

When you select Restore Defaults from the File menu in the Setup Parameters or Quick Setup window, the default action of the terminal is to read the parameter settings in the remote configuration file loaded by the terminal. Using the config-default-file parameter, you can specify a different file for this purpose (Setup -> Change Setup Parameters -> Configuration -> [Configuration Daemon Service section] Default File).

Table 6-8 config-default-file Parameter
Possible Values
Result
default The configuration file loaded by the terminal.
filename The pathname of the file to be used as the default file.



[Top] [Prev] [Next] [Contents] [Index]

Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights reserved.