[Top] [Prev] [Next] [Contents] [Index]
XREMOTE Messages
XREMOTE messages pertain to communications using XRemote software. If you are looking for a message that refers to the XREMOTE module but does not appear here, refer to "Messages Common to All Modules".
CONNFAIL, connection from host failed - host not authorized
- Severity:
- Error
- Explanation:
- The terminal's X access control list does not include an entry for
the XRemote host, thereby preventing connection.
- User Action:
- Verify that the terminal is attempting to connect to the correct
XRemote host. If it is, modify the host access list on the terminal so that it
includes an entry for the XRemote host.
CONNREJ, new client connection rejected = message
- Severity:
- Information
- Explanation:
- An XRemote client is attempting to connect to the X server but
is unsuccessful as detailed in the message. This situation usually occurs if the
terminal is low on memory.
- User Action:
- Refer to the message for more information about the situation. If
the terminal is running low on memory, close any unused local clients to free
memory for the XRemote client connection.
FILETXFER, error during file transfer - message
- Severity:
- Error
- Explanation:
- The X server has detected an internal error.
- User Action:
- If you encounter this message, please contact NCD Technical
Support for assistance.
NOMEM, out of memory - message
- Severity:
- Error
- Explanation:
- The X server does not have sufficient memory to perform the
requested action.
- User Action:
- Close any unused local clients to free memory for the desired
function.
NOMORE, new connection_type connection refused - XRemote already running
- Severity:
- Error
- Explanation:
- The X server has received a request to initiate XRemote
communications when it is already running.
- User Action:
- Either use the original XRemote session or close the original
XRemote session and start a new one.
REFUSE, New network connection refused - message
- Severity:
- Error
- Explanation:
- This message usually appears when the X server is not
configured correctly for XRemote communications.
- User Action:
- Verify that the X server is configured correctly for XRemote
communications. Specifically verify that the terminal is configured for
XRemote communications via TCP.
TXPORT, message
- Severity:
- Warning
- Explanation:
- The X server has encountered difficulties in the transport layer
of XRemote software as specified in the message.
- User Action:
- Use the information contained in the message to resolve the
problem. If you require further assistance, please contact NCD Technical
Support.
[Top] [Prev] [Next] [Contents] [Index]
Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at
techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights
reserved.