[Top] [Prev] [Next] [Contents] [Index]

XRPRINTD Messages

XRPRINTD messages pertain to the XRemote print daemon. If you are looking for a message that refers to the XRPRINTD module but does not appear here, refer to "Messages Common to All Modules".


CLOSE, closed session on port
Severity:
Information
Explanation:
The print daemon closed the connection to the serial/parallel daemon on the specified port.
User Action:
None

NOCONNECT, unable to connect to print daemon on port

Severity:
Error
Explanation:
The XRemote print daemon is unable to connect to the serial/parallel daemon on the specified port.
User Action:
Make sure that the serial port mode (Setup -> Change Setup Parameters -> Serial -> Serial Interfaces Table -> Current Port Use) has been configured for printing.

OPEN, opened session on port

Severity:
Information
Explanation:
The print daemon connected to the Serial or Parallel daemon on the specified port.
User Action:
None


[Top] [Prev] [Next] [Contents] [Index]

Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights reserved.