next up previous contents
Next: Graphic Plot of top-view Up: The Selection of Graphic Previous: The Selection of Graphic   Contents

Graphic Plot of Trajectories in x- and y-direction

A graphic output of single particles is obtained by a command very similar to the printer plot by: 13 D(RAW) B(EAM) <shown maximal x-width in meter> <shown maximal y-width in meter> <number of steps in z direction> <x0: number of trajectory starting points in the x-coordinate> <a0: number of trajectory starting points in the a-coordinate> <g0: number of trajectory starting points in the g-coordinate> <d0: number of trajectory starting points in the d-coordinate> <y0: number of trajectory starting points in the y-coordinate> <b0: number of trajectory starting points in the b-coordinate> <no: type of multidimensional phase space> ; [example: D   B   0.1   0.1   100   2   2   1   3   2   2 ;] [default: D   B   0.1   0.1   1   1   1   1   1   1   1 ;]
no=1, ions start only either in x or y plane, from a parallelogram like phase space volume
no=2, ions start in all combinations of x and y, from a parallelogram like phase space volume
no=3, ions start only either in x or y plane, from an elliptical phase space volume
no=4, ions start in all combinations of x and y, from an elliptical phase space volume
[.5cm] The calculation is performed to the order given in the CO-command.

The total number of starting points of trajectories is distributed equally spaced within the initially defined phase-space areas x0,a0 or y0,b0 or within the range of masses (g0) and energies (d0) as defined in the DP-command. Note that the total number of trajectories increases rapidly according to the number of combinations of coordinates. This command may occur only once.
next up previous contents
Next: Graphic Plot of top-view Up: The Selection of Graphic Previous: The Selection of Graphic   Contents
KPII
1999-10-20